Applying Fabric and Trims to Webbing



Lightweight cotton fabric-twice the width and 1" longer than webbing.

Wonderunder-2 pieces same size as webbing.

1. To prevent fraying, fuse cut ends of webbing by passing the webbing several times through flame of a lit match.

2. Cut fabric piece twice the width of webbing and 1" longer than length. This will produce a fabric piece that will cover the webbing completely, from side to side.

3. To produce a fabric piece that will allow edges of webbing to show, trim 1/4" from one long edge of fabric piece. See third illustration below.

Wonderunder by Pellon is widely available at Wal-Mart and fabric stores. It is a fusible web product on a paper backing, usually located with the interfacings.

4. Using webbing as a guide, fold short ends of fabric piece under to fit to length of webbing. (not illustrated)

5. Fold long edges of fabric piece to center and press in place. 

6. Remove paper backing from one piece of Wonderunder.

Main Site Menu
Home Page
Pet Collar Kits
Collar Refill Sets
Metal Hardware
Brass Hardware
Plastic Hardware
Webbing & Paracord
FAQ & Policies
Projects & Ideas
Projects & Ideas Menu 
Key Keeper Ideas
Collar & Leash Ideas
Collars Strap Ideas
Accessories & Household Ideas
Tutorial for Classic Collars
Tutorial for Bracelets
Tutorial for Fabric Collar Straps
Tutorial for Leash Friendly-Safety Breakaway Collars
Using Brass or Nickel Plate Loops
Martingale Project Ideas
Using Martingale Chains
Applying Fabric and Trims to Webbing
Fabric Cutting Measurements
For using 1.5 & 2" hardware

7. Open fabric piece and lay Wonderunder down center, trimming to fit within pressed lines if necessary.

8. Refold fabric around Wonderunder and press in place.

9. Trim second piece of Wonderunder so it is narrower than fabric piece. See illustration below.

10. Lay second piece of Wonderunder, paper side up, on back side of fabric piece. Press in place.

11. Allow piece to cool completely, then peel paper backing off.

12. Center fabric piece on webbing, right side up. Press in place, then stitch along edges. 

 Back to Webbing To apply ribbon or trims to webbing, fit trim to webbing as in step 4, then follow steps 9-12.